Serving Berthoud, CO
Local contractor in 80513
Recent projects near 80513
Real work completed for homeowners in Berthoud and the surrounding areas.

Furnace Parts Replace
Performed furnace cleaning and tune up. Cleaning: removed and disassembled the blower assembly. Cleaned fan and blew out motor. Scraped away sheet rock dust from the secondary and coil. Took coil spray and coated both. Let soak for 15 minutes. Wiped down and sprayed again. Took a brush and carefully brushed away as much debris as possible. Got the coil as clean as it’ll get without removing it. Assembled all back together and did the tune up. Tune up: filter is clean and is replaced every month. The heat exchanger has rust formed inside of the heat exchanger. This was probably cause by the airflow due to sheet rock dust. The inducer was over amping. This will eventually fail. Will check with carrier about warranty status. Unit is currently heating the home.

AC Tune Up
2024 Carrier. This is a new build house. Found secondary HX, blower wheel/assembly and evaporator coil all clogged up with drywall dust/mud. Duct work is clean but everything inside of furnace compartment is dirty. Spoke with Mark and Pat and sending over estimate for a full system rejuvenation. While testing the AC, found that readings for subcooling were very low (target 10/ reading less than 1). This could be caused by a combination of things including low air flow from dirt in system or low refrigerant in system. Recommend cleaning system first and then go forward from there. They said they were happy with the way the AC performed this summer, cleaning system will only make that better. Also, found water in burner compartment next to trap. I cleaned trap and resecured drain clamp. A furnace tuneup is scheduled next week and will need to check to see if issue was resolved. Also spoke about maintenance program and will include estimate for that as well. Please contact office if you would like to schedule any repairs. Thank you!

AC And Furnace Tune Ups
During our visit, we conducted two furnace and AC tune-ups, ensuring that the systems were operating effectively. We found the blower wheels on both furnaces and the basement unit’s secondary heat exchanger to be dirty, recommending cleaning to maintain optimal performance. The upstairs AC unit had stripped threads preventing suction pressure checks, while the basement unit’s capacitor is showing low readings and will need replacement next summer. Both heating and cooling systems are functioning well at this time.

Furnace Maintenance
Systems heat exchanger is in fairly rough shape for the age. Unit is still running at this time without active faulting however, during my visit we spent time discussing filtration upgrade, club membership for future service and savings on replacement parts and cleanings. Thank you so much for your business!

Furnace Tune Up
Performed 2x furnace tune ups. Both filters were replaced. No major issues to address with either unit. Both were wiped down and are now ready for winter. Systems are operating within manufacture specifications and are heating at this time. Please see attached form for further details regarding today’s visit.

Furnace Maintenance
We conducted thorough furnace tune-ups for both units, ensuring optimal performance. After careful inspection, we identified no major issues, confirming that both systems are functioning properly at this time, providing peace of mind for the homeowner.

Furnace Tune Up
During the inspection, we found that the system, operational for three years, was running efficiently with no significant issues. We noted a buzzing sound from the transformer; however, it was verified to be functioning properly. An invoice, along with a detailed report, has been sent for processing.

Furnace And AC Tune Up
The AC was experiencing fluctuating refrigerant pressures and insufficient temperature drop across the coil. We checked the system and confirmed a potential issue with the vacuum during installation which is causing the TXV to fail. We recorded a 17-degree temperature drop, which is at the lower end of the optimal range. While everything is currently functioning, we recommend monitoring performance on hotter days. The furnace is running smoothly, with minor dust buildup on the blower wheel and secondary heat exchanger which we will keep an eye on. We adjusted the gas pressure, cleared the drain, and cleaned the flame sensor. The filter was in good condition, and all system tests showed normal operation.

Air Conditioner Tune Up
Performed ac tune up. Filter is clean and replaced on a monthly basis The outdoor unit was rinsed off. The only issue that was discovered was high amp draw during start up for the compressor and the contactor beginning to pit. Recommend replacing contactor and adding a hard start kit. Other than that the unit is cooling great at this time.

AC Diagnostic And 2 Furnace Tune Ups
During the service visit, we conducted a thorough AC diagnostic and replaced the run capacitor to ensure the system operates efficiently. Additionally, both furnace tune-ups were performed, and we confirmed that there were no major issues found. Currently, the systems are functioning properly, providing peace of mind for the homeowner.

Air Conditioner Diagnostic
We identified a faulty dual run capacitor that was affecting system performance. Following Isaac's earlier recommendation, we replaced the capacitor and conducted thorough testing. As a result, the temperature drop was impressive at 20 degrees, ensuring the system operates efficiently again. Everything is functioning well at this time. Thank you.

Air Conditioner Diagnostic
During our inspection, we found the furnace and AC unit, dating back to 1993 respectively, struggling due to a loss of R22 refrigerant. We diagnosed the system, noting that it was drawing 130 amps at startup and identified a popped dual run capacitor along with a compromised contactor. We found the evaporator coil severely rusted, rendering a temporary fix impractical given the unit's age and the use of obsolete refrigerant.

Furnace And AC Tune Up
A malfunctioning blower motor was identified during the furnace tuneup, leading to its replacement along with the spark ignitor and the IFC board. We also performed tests to ensure all systems were operating correctly in heating, cooling, and fan modes. Additionally, we discovered a grease leak forming on the outdoor AC condenser fan and recommended monitoring it for any changes.
What Berthoud homeowners are saying
A 5★ average rating from 5 verified reviews.
Isaac was very professional, thorough and explained eveything very well.
This company is really amazing. We needed to check how to keep our outside air conditioning equipment safe and working during the winter. Our professional tune up guy, Chris, came and cleaned out the equipment then told us what to do to keep it running smoothly. He came back again to check our furnace and inside Heating equipment, replaced a motor and left us with great clean quiet smooth running air. The company responded quickly and was very professional.
