Serving Severance, CO
Local contractor in 80550
Recent projects near 80550
Real work completed for homeowners in Severance and the surrounding areas.
Humidifier Installation
To ensure optimal air quality and efficiency in the client’s home, we installed an Aprilaire air filter, specifically the Winaire 20X20X5 model. This upgrade enhances the HVAC system's performance by effectively trapping dust and allergens, promoting a healthier living environment.
Furnace Parts Replace
The furnace was experiencing performance issues due to a faulty flame sensor. We replaced the defective component and ran the system to ensure it operated efficiently. Following the repair, we confirmed the heating was working properly and reliably for the customer’s comfort.

Furnace Tune Up
This 1998 Heil is in pretty rough shape however, all things considered the issues discovered are normal for a furnace This old. Heat exchanger has temperature stress points all over and is beginning to rust through on compression rings. Circuit board on this furnace is burnt and induced draft motor is pulling higher amp draw than stated on data plate. Furnace is no longer drafting effectively, which is leading to hot gases, causing damage to heat exchanger and creating condensation during combustion. During this appointment we spent time discussing Band-Aid repair options, stretching out to long live options as well as most permanent solution, being replacement of the furnace, given the age and ballpark figures for repairs.

Furnace Diagnostic
Upon arrival customer had an issue with the water heater misting water onto the furnace. They wanted to make sure no damages were done to the unit. Performed furnace tune up. The filter was dry and clean. I visually inspected the unit. Half way through my camera died so I couldn’t add the photos to the job, but everything I saw looked ok. The control board was not hit with water. Unit is fully functional. I did find water leaking from the collector box where the condensate trap was connected. Spoke to customer about this, today I removed it, added teflon tape and fully fastened it down. Let unit run and no leaks present. Reminded customer about the ac coil. They are aware and we will check the unit in the spring. System is heating at this time.

Furnace Tune Up
Furnace tuneup -10 year old Lennox During inspection, found secondary heat exchange has some dirt/debris built up on it and is partially restricting airflow thru furnace. Low airflow can lead to higher than normal temperatures in heat exchange and burner compartment which can lead to premature failures of components in heating system. It can also decrease efficiency and performance of heating and cooling sides of the system. Also noticed while the blower motor is running, it has a rattle sound to it. This could be caused by different things and would need to investigate further to find cause and correction. Everything is working today and testing in specs. I replaced air filter and set up humidifier for winter. No charge today. Thank you!

Furnace Tune Up
Amana furnace looks good. Filter recently replaced. Humidifier pad looks good. Opened damper on humidifier and set humidity to 30% and is ready for winter. Trane furnace same as last year. Cracks at crimps in heat exchange and Bob is aware of potential health and safety concerns. No CO detected today while testing. Will include estimate for warranty repair. We will need to order and it may be a few weeks out. I replaced run capacitor on blower as it was testing low.

Furnace Diagnostic
Wire was undone from the W1 wire on this furnace upon my arrival. I spent time wiring the circuit board up correctly and watched the furnace fire properly for the remainder of my visit. I have recommended a maintenance program in order to start taking care of this furnace and setting gas pressures based off of the rust that’s occurring on the inside of the heat exchanger.

Furnace Tune Up Membership
Performed furnace tune up. Replaced the 16x25x1 filter. As previous techs mentioned the blower wheel and secondary heat exchanger are dirty. Per request, I will resend the estimates. Humidifier is set up for the season, no leaks present. The unit is heating as intended but can improve by doing the cleanings of the components and a duct cleaning to help prevent more dust accumulating. Upgrading filtration system can also help.

Furnace Tune Up
Everything runs smoothly on this 2017 Armstrong air furnace. System was thoroughly vacuumed out and cleaned during my appointment. All mechanical measurements are within specs at this time. No major issues to address. I let Chris know that I would contact the office and get the subscription for the monthly auto draft payment of $12 for his club membership all sorted out. Thank you so much for your business!
Furnace Diagnostic
When I arrived, I found that the belly band on the blower motor had completely broke off three of the mounts and the blower wheel was coming in contact with the squirrel cage. I tested the motor. Everything tested good so I replaced the belly band and have everything running again at this time.

Furnace Tune Up
System runs without faults. Light dirt build up that gets around EAC filter is normal. No major issues at this time. Secondary heat exchanger and blower assembly could both be proactively cleaned and this was the only discussion primarily that we had while I was scheduled out. Thank you so much for your business.

Furnace Tune Up
During the job, we noted the potential formation of a hot spot on the igniter, which we monitored closely while confirming that it was still functioning within specifications. We set the humidistat to 35%, ensuring optimal humidity levels, and made a note that the damper will need to be opened when the time is appropriate. All systems were tested and confirmed to be working well.

Furnace Tune Up
Furnace Tuneup Everything is clean, testing in specs and working well at this time. Did find a hot spot beginning to form on igniter but testing ok at this time. Humidistat is set to 35%. Damper will need to opened when comes time. Replaced filter that Dan provided.

Furnace Maintenance
Upon inspection of the 18-year-old furnace, we identified several concerns, including rust in the heat exchanger and a dirty blower wheel with potential oil spots. The blower motor capacitor was below specifications and should be replaced soon. We noticed an unusual scraping noise from the induced draft motor that could indicate future failure. Overall, we discussed the unit’s age and recommended considering an upgrade for improved efficiency and longevity.

Furnace Tune Up
Performed furnace tune up. Replaced 1 inch filter. During the visual inspection, I found the blower wheel dirty. Compared to previous visit in may, not much changed. Cleaning recommended. The heat exchanger does have some heat stress points. Not horrible but something we need to monitor in the coming years. It’s normal wear and tear for a 6 year old builder grade furnace. No further issues to address. System is operating within manufacture specifications and is heating properly at this time. Please see attached form for further details regarding today’s visit

Air Conditioner Diagnostic
A significant buildup of dirt, dust, and dog hair was restricting airflow and causing system freeze-up. We recommended to get the evaporative coil, secondary heat exchanger and blower wheel cleaned. we also explained that we could install a better filter system to fix this problem going forward.

AC Diagnostic
After identifying widespread failures in a 26-year-old system, we meticulously evaluated the issues at hand. We gathered data to formulate detailed estimates for both replacement and repair solutions. This comprehensive analysis will be shared promptly to assist in making informed decisions for improvements.

Furnace Tune Up
We conducted a thorough furnace tune-up to ensure optimal performance. The 4-inch filter was cleaned, and we recommend switching to traditional filters instead of the electrostatic filter system. The unit is running smoothly, and the humidifier is ready for the winter season. The system is currently operating without any issues. Please see the attached form for more details regarding today’s visit.

Furance Parts Replace
The existing motor was experiencing issues, prompting us to install a new one. After the installation, we confirmed that the amp draw settles at .7 in high stage heat. A successful cycle test was performed, ensuring everything is functioning properly, with no further issues to address at this time.

Furnace Tune Up And Tanked Water Heater Flush
Furnace tune up and tanked water heater flush. This 2012 Bradford White water heater has a failure in the drain valve that is creating a spray when the valve is partially opened. During this appointment I was able to successfully flush the water heater. The furnace is a 2012 Rheem that is currently running properly and without fault. During this appointment, we discussed replacement of the drain valve for the water heater as well as details included in the club membership. Thank you for your business.
Job in Severance
The issue with the water heater was the pilot light not staying lit, prompting a need for investigation. We diagnosed the problem and found the thermostat coupling unit was faulty despite a recent replacement. After securing and adjusting the components, we restored functionality to the pilot light, ensuring the water heater operates efficiently once again.

Furnace Tune Up
This 2024 carrier runs great. Gas pressure was high upon adjustments and internals of heat exchanger are slightly rusty. This is common at elevation when gas pressure is too high. Adjusted to low side of spec and other measurements look good and are within spec at this time. While I was scheduled out, we all spent time discussing benefits, built into the club membership for future service and savings. Filtration system could be upgraded to prevent further saturation on the internals of the furnace, such as the blower wheel, secondary heat, exchanger, etc..

Furnace Tune Up
Performed furnace tune up on a 2 year old Amana. Filter is clean and replaced by customer. No major issues to address today. The unit was wiped down and tested. Furnace is operating properly and is heating at this time.

Air Conditioner Repair
Performed evaporator coil cleaning and blower wheel cleaning. I tested the operation after cleanings. Air is now coming from the vents. 16x20x1 filter was installed. Replace filters every 30 days. System is cooling at this time.

Furnace And Air Conditioner Tune Up
During the inspection, we identified a carbon monoxide level of 3 ppm within the breathable airspace, which requires immediate attention. We cleared a clogged P-trap in the air conditioner’s primary drain for a temporary fix, but recommend rebuilding it with a blowout T for a long-term solution. Additionally, we noted a rusted evaporator coil and low refrigerant charge, issues commonly found in builder series units around 10 to 11 years old.

Furnace And Air Conditioner Tune Up, Tankless Water Heater Flush
Performed furnace and ac tune up along with a tankless water heater flush. Furnace: the unit is operating well. The filter was replaced. Gas pressure was adjusted. The heat exchanger has some heat stress which is normal. No major issues as of now. Unit is heating at this time. AC: outdoor coil was rinsed. The refrigerant pressures are within manufacture specs. The capacitor is reading ok. Found no major issues. Unit is cooling at this time. Tankless water heater: allowed descaling for the duration of the furnace and ac tune ups. I flushed out any remaining vinegar left in the tank. Removed screen and cleaned. Removed flame sensor and cleaned. Checked operation. Unit is functioning properly at this time.

Tankless Flush, Furnace, And AC Tune Ups
We completed a comprehensive furnace and air conditioning tune-up along with a flush of the tankless water heater. The furnace was verified to be in good operating condition with a filter replaced and gas pressure adjusted. The AC unit showed no major issues, maintaining proper refrigerant pressures and functioning effectively. The tankless water heater was descaled, cleaned, and is now working properly.

Furnace & AC Tune Up
he furnace here is in very rough shape currently. Front cover has cracked so badly that condensation waters leak all over into the furnace and have rusted the internals out badly. The primary heat exchanger at 21 years is currently rusting internally and externally around the first bends and has began delaminating inside of first bend. Induce draft motor is pulling high amps and blower motor is suffocated due to years of running and standard filtration. Blower wheel is saturated and no longer scoops air effectively due to being overweighted. All these issues are common for. 21 year old furnace. AC is a 12 year old Amanda that is running on Low refrigerant and has a failing run capacitor that requires the system to pull high amp draw at start. This system is cooling at this time however run capacitor should be replaced and a compressor saver should be installed with a refrigerant top off to keep the system running. Repairs can be performed on both furnace and AC to prolong the life of units if this makes sense. Recommended repairs have been discussed with Corey for reference.

Air Conditioner Maintenance
Upon my arrival today to perform my A/C tuneup, I attempted to turn this air-conditioning system on, and the unit would not turn on. I discovered that thermostat that was installed recently was not sending signal out to the condensing unit and had been wired incorrectly. I spent time rewiring the system and performing measurements while I was scheduled out. This unit is pulling high amp draw at start and during my appointment. The homeowner and I discussed the installation of the compressor saver kit, in an attempt to prevent further depletion of the run capacitor and a no cool in the future. Thank you so much for your business!

AC Tune Up
Performed ac tune up. Filter needs replaced. I had run out of truck stock but customer will replace. The blower wheel and secondary are dirty but customer is aware. Unit is working fine. The indoor temp is at 62°. This throws off the refrigerant pressure readings. Delta t was good and customer hasn’t had any issues. System cooling at this time.
What Severance homeowners are saying
A 5★ average rating from 17 verified reviews.
Good communication and explanation of services and if there was issues.
Very honest company, Isaac T. was amazing. We will definitely be using them again in the future!
Great install job for a new Amana central A/C system. Excellent, responsive service at a fair price, particularly for supporting a NOCO locally owned and operated company. Staff explained everything transparently and well-answered every question I had. Will likely sign up for their annual service package.
Quick and efficient did a great job!
Chris made sure that we had our air conditioner working before they left on the first day of the install.
Isaac is great . We greatly appreciate his honesty
Chris was on time. Explained what was involved with the fall check and has us ready for winter. Very pleasant well trained. Highly recommend.
Air conditioner tune up. Isaac N very professional. All areas required were checked and recorded. No "pushing" about other products. My questions were answered. Would recommend this company with all HVAC needs. Great job! Thanks
Called them on Tuesday for a tune up and was able to get n appointment the next day. Lucas was very nice and knowledgeable. Will do business with them in the future.
I’ve used Long Heating and Air for a couple different services now and they won me over from the very beginning. They aren’t pushy at all and it feels like they truly are all about just helping and providing great service.
My experience with Long Heating & Air and their staff from start to finish - including my rebate application and completion - was helpful and instructive, efficient, and cheerful! Great overall.
We first utilized their services upon buying a new home and have since used them for all of our A.C.And heating needs! This company is very reliable dependable, they get the job done and at a fair price!
Dylan T came out and got our furnace up and running in no time! They are our go to HVAC company. Always
Excellent furnace service. Isaac did a very thorough job of doing a winter service of our furnace. We like to keep our HVAC system on a service contract so we know our system has been checked every year and is working the way it should. But we dropped our last contract with our last company because of the way their technician behaved on the last visit. I like to watch when the service is being performed and the job Isaac did compared to our previous services was much more thorough. It gave me more confidence that the furnace would be working properly for the rest of the season. Isaac took the time to go over with me what he found with his service. There were some miner issues but he said he was comfortable with just keep an eye on them rather than push for some sort of repair. The efficiency, knowledge demonstrated, and thoroughness of the inspection gave me confidence in his judgment.
Dylan was awesome! He worked to fix my AC quickly and communicated what happened and what he was doing to fix it.
